Self-regulating heating cable


  • For snow melting, ground
  • Laid in a sand bed or embedded in concrete
  • Kabel
  • Power off: 80 °C
    80 °C
  • Power on: 100 °C
    100 ºC
  • High power per meter
  • Can be cut during installation for good fit
  • Can be crossed during installation
The self-regulating heating cable ELSR-Ramp is intended for embedding in concrete for outdoor snow melting, such as in parking garages, ramps, and stairs.



Specification Data
Connection voltage 230 V
Number of conductors 2 pcs
Bending radius, min. 50 mm
Output 50 W/m at 10 ºC, 110 W/m at 5 ºC (embedded in concrete)
Exposure temperature (power off), max. 100 ºC
Exposure temperature (power on), max. Up to 80 ºC
-BO Protective conductor: Braided, Outer casing: TPE
Installation temperature, min. -20 ºC
Insulation material outer TPE
Cable type Self-regulating 2-conductor with screen
Conductor area 2,77 mm²


The general terms of delivery are listed below.

Our warranty terms



*¹ Heating circuit lengths on the following conditions

  • 230 V nominal voltage
  • Delayed action circuit breakers (C-characteristic) with 80 % max. load
  • Maximum 10 % line voltage drop on heating cable bus wire
  • Power connection to one heater end
  • In certain installation situations, the heating circuit length may vary. Please contact our engineers.